Electrolux ERC07002W8 Notice D'utilisation page 6

6 electrolux
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
A
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
1. Remove the plug from the power socket.
2. Remove the top hinge cover.
3. Unscrew the 2 retaining screws, and remove
the hinge from the appliance.
4. Take the door off.
5. Remove the screw fixing the lower door
hinge and the other screw fixing the lower
door hinge and the foot. Then remove the
door hinge and the foot as shown in the Figure.
6. Loosen the screw fixing the foot opposite the
lower door hinge in order to remove the foot.
B
2
1
7. Fix the door hinge and the corresponding
foot on the opposite side and then the other
loosened foot at the former place of the door
hinge as shown in the Figure.
8. Please make sure to place the lower
foot below the door hinge. The lower
foot is recognizable by its 4 ribs on the
outer surface.
9. Fix the door onto the lower hinge pin.
10. To fit top door hinge, remove the plastic blank-
ing plugs carefully, and refit them in the holes
left by the hinge retaining screws.
11. Refit the top hinge using the 2 retaining
screws, taking care that the edge of the door
is parallel with side of the cabinet.
12. Replace the hinge cover.
13. Relocate the handle and the plastic plugs to
the opposite side.
14. Level the appliance, wait for at least four
hours and then connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-