Installation; Drilling The Support Surface And Fitting The Hood - Progress PDP9030E Notice D'utilisation

INSTALLATION

Drilling the Support surface and Fitting
the Hood
• The Hood can be fitted directly on the lower
surface of the Wall Units (650 mm min. abo-
ve the Cooker Top) using the snap-on Side
Supports.
• Make an opening on the lower surface of the
Wall Unit, as indicated. (fig.1)
• Choose the correct flange measure basing
on the air outlet diameter and insert it to the
upper air outlet opening. (fig.2)
• Screw the closing profile 20 onto the rear part
of the hood, using the screws 12f (2.9 x 9.5)
provided. (fig.3)
• Open the sliding suction panel.
• Remove the metal grease filters one by one
after having disconnected the relative fas-tening
elements.
• Close the sliding suction panel again.
• Insert the Hood until the snap-on side sup-
ports click into place. (fig.4)
• Open the sliding suction panel.
• Lock in position by tightening the screws Vf
from underneath the Hood. (fig.4)
• If necessary, adjust the whole filter holder unit
and proceed as follows:
• Loosen the four adjustment screws Vr and
close the sliding panel again. (fig.5)
• Move the entire filter holder unit until it is
properly aligned with the wall unit. (fig.6)
• Keeping the hood canopy still, remove the
sliding panel and lock the adjustment screws
again. (fig.5)
• The hood can now be fastened to the wall unit
using the four screws 12a (3.5 x 16) provided.
(fig.7)
• Replace the metal grease filters.
• Close the sliding suction panel again.
1
162
523
3
4
6
progress
2
5
7
12a
33