Operating Tips; Cleaning And Storage; Troubleshooting - Vornado V-Flow Circulation Mode D'emploi

Operating Tips

Getting the Most From Your Circulator
Thank you for your purchase. It's important for you to know that this
product functions very differently than typical tower fans you may
have used in the past. Here are a few things to keep in mind:
Expect Powerful Circulation
Your Tower Circulator is designed to move considerably more air than
a traditional tower fan. Consider the following as you adjust product
settings.
Turbo Setting Ultra-high volume airflow. Increased sound lev-
(184 and 154 only) els may be perceptible due to airflow volume
and velocity.
High Setting High volume airflow. Rapidly moves air across
the room for efficient cooling. Increased sound
levels may be perceptible due to airflow volume
and velocity.
Middle Setting(s) Superior circulation power compared to tradi-
tional tower fans on their high setting. May be
preferred for day-to-day use.
Low Setting Near-silent operation while offering steady cir-
culation.
10 English

Cleaning and Storage

How to Clean
Your Tower Circulator has no user
†
serviceable parts. Do not disassemble
the unit. This will void your warranty. If
service is required, return your circulator
to Vornado (see WARRANTY for
instructions on page 12).
View cleaning tutorial
† The motor is permanently lubricated
on your mobile device.
and requires no oiling.
Because your Tower Circulator moves a substantial amount of air, it
will need regular cleaning. To clean follow these simple instructions:
1.
Unplug the unit.
Note:
Do not use gasoline, thinners, solvents or other
chemicals for cleaning .
2.
Use the brush attachment on your household vacuum
cleaner to vacuum any accumulated dust off the Front
Angled Outlet Grill and Side Inlet Grill. Wipe down the
entire surface with a soft cloth.
Storage
It is recommended to store your Tower Circulator by following these
instructions:
1. Unplug power cord and bundle loosely.
2. Thoroughly clean your Tower Circulator (see instructions above).
3. Cover, or place back in retail carton if available. This will prevent
the unit from accumulating dust overtime.
4. Store unit in a cool and dry location.
Problem Possible Cause and Solution
Unit fails to Unit is not plugged in. Plug Power Cord into electrical outlet.
power on.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Fuse needs to be replaced. See IMPORTANT INSTRUCTIONS for how to replace the fuse or contact Consumer Service.
Unit is not pro-
Ensure unit is set to highest setting for maximum air circulation.
ducing sufficient
amount of air.
Allow the unit to fully circulate the air throughout the room, this may take several minutes.
Ensure all air inlets and outlet grill are unobstructed.
The battery is packaged separately and may not be installed. Refer to CONTROLS - Remote Control Battery on page 9
Remote Control
for instructions.
is not working.
The battery is dead. Replace with new 3 volt CR2032 battery. Refer to CONTROLS - Remote Control Battery on page 9
for instructions.
The remote requires a line-of-sight path to allow for the signal to be received by the unit. Position the unit so the
receiver lens (located above the Vornado logo) is visible from the remote control.

Troubleshooting

English
11