Publicité
Step 9
Carefully turn your unit over onto its front edges. Unfold the UPPER BACK (G) and lay it over your unit.
å
Make equal margins along all four edges of the UPPER BACK (G). Push on opposite corners of your unit if needed to
å
make it "square".
Fasten the UPPER BACK (G) to three edges of your unit using the NAILS (1N).
å
NOTE: Do not tap nails into the bottom edge of the upper BACK at this time.
å
Position the LOWER BACK (H) over the lower portion of your unit, making equal margins along the bottom and side
å
edges.Fasten the LOWER BACK (H) to three edges of your unit using the NAILS (1N).
NOTE: The LOWER BACK (H) will overlap the UPPER BACK (G) as shown in the enlarged diagram. Fasten the LOWER
å
BACK and UPPER BACK to the CENTER SHELF (F) using the remaining NAILS (1N).
NOTE: Perforations have been provided for access through the BACKS. Carefully cut out the holes needed.
å
NAIL
(58 used in this step)
This perforation should be here.
www.sauder.com/services
Caution
Do not stand the unit upright without the
1N
BACK fastened. The unit may collapse.
H
Fasten the upper
BACK (G) fi rst.
G
418734
This perforation
should be here.
Do not fasten NAILS along this
edge until the lower BACK is
overlapping the upper BACK.
The lower BACK
overlaps the
F
upper BACK.
Page 13
Publicité
