peerless-AV SAX755PU Mode D'emploi page 8

For Flat Back Display
2-1 Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as shown
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not overtighten.
If screw cannot make three full turns into the display, select a longer length screw from the baffl ed fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
2-2 Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not overtighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
DISPLAY
SPACER
ADAPTER
8 of 38
fi g. 2.1
MULTI-WASHER
SCREW
ADAPTER BRACKET (B)
fi g. 2.2
MULTI-WASHER
SCREW
BRACKET (B)
ISSUED: 01-25-12 SHEET #: 095-9368-6 01-07-14