Adjustment Of Flat Panel Display - peerless-AV SAX755PU Mode D'emploi

4-1
Insert two M8 x 16mm screws into top two mounting
holes of display, leaving approximately 1/4" (6mm)
of exposed thread. Hook screws onto keyslots of
front plate as shown.
M8 X 16MM SCREWS

Adjustment of Flat Panel Display

Tension Adjustment of Ratchet Handle: Adjust
5
tension of tilt assembly by rotating ratchet handle.
NOTE: If obstruction prevents ratchet handle from
rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Tilt Adjustment: Adjust ratchet handle on side of
mount to desired tension to enable tilt adjustment
and balance your display size and weight. Push
or pull from top or bottom of display to adjust tilt
as shown. The tilt can be adjusted to a maximum
of 15° forward or 5° backward. Retighten ratchet
handle.
Vertical Height Adjustment: Loosen or tighten
vertical adjustment screw using 5mm allen wrench
(J) to raise or lower position of fl at panel display
+/- 0.70".
CAUTION
• Do not tighten screws with excessive force.
• Be careful not to pinch fi ngers when opening and
closing mount from the wall.
4-2
FRONT PLATE
10 of 38
Insert two M8 x 16mm screws into bottom holes of
adapter plate as shown, then tighten all fasteners.
M8 X 16MM SCREWS
RATCHET HANDLE
ISSUED: 01-25-12 SHEET #: 095-9368-6 01-07-14
VERTICAL
ADJUSTMENT SCREW