Power Connection; Gas Connection - Amsta AMCG60BM Notice D'utilisation

Power connection

The product should be definitely used with an earthed line!
The manufacturer will not be responsible for any damages that may
occur if it is used without earthed line.
Any risk of electric shock, short circuit or fire due to installation made by
unprofessional persons! Connection of the product to the mains may be performed
only by an authorized and competent person and the warranty of the product starts
only upon correct installation.
Risk of electric shock, short circuit or fire caused by use of damaged power cable!
The power cable should not be crushed, twisted or compressed or should not
contact with hot parts of the product. If the power cable is damaged, it should be
replaced by a competent electrician.
• Mains supply data should be same with the data given on the nameplate of the unit.
Nameplate of the product is on the rear.
• Connection cable of the product should comply with the technical
power consumption.
Risk of electric shock! Prior to starting any work on the power installation, please
disconnect the product electrically. (Figure 3)

Gas connection

Any work on the gas equipment and systems should be performed by the
authorized and competent persons.
Prior to installation, check that the local supply conditions (gas type and gas
pressure) are compliant with the product settings.
LPG connection
Be careful that the gas hose and gas valve you use for your oven should be safe. Attach
the gas supply hose at the hose end being the oven and tighten by means of clips and
screw (Figure 4). Make sure it is tightened.
Gas hose of the oven should be me longer than 1500mm.
Pressure of the valve to be used for LPG should be 30 mbar- 300mmSS and certificated.
(Figure 3)
11
specifications and