Villager VLS8T-01S Mode D'emploi page 30

Never dispose the residual fluids into household waste too. It must be collected separately and
disposed of in an environmentally correct manner too.
TROUBLESHOOTING
Type of malfunction
When the control hands
is pushed down. The wedge
doesn't tower
Ram won't retract
Wedge moves slowly or
Will not extend completely on
normal log
Ram stops during splitting
Hydraulic hoses
heat-up excessively
Motor won't start
The electric motor heat-up
excessively
STORAGE
When you have finish working with your log splitter:
1. Disconnect the log splitter from the mains supply.
2. Tighen the oil yank cover / air bleeder,
3. Clean the unit down ising a dry cloth.
4. Store in a dry and well-ventilated area.
Possible origins of the problem
-Oil level is too low
See above
-Oil level is too low
-Wrong valve détente
-Pump is broken
-Cylinder gaskets are
damaged
-Log is too big, crogged or with
lots of branches
-oil level too low
-Pump is damaged
-Wrong valve detente
-Faulty plug/socket
-Faulty/damaged electrical
cable
- Cable section is too small
- Motor winding is damaged
14
Solutions
-Fill oil in
See above
-Fill oil in
-Adjust valve
-Replace pump
-Replace gaskets
-Turn/adjust log position
-Fill oil in
-Replace pump
-Adjust valve
-Replace plug/socket
-Replace cable
-Replace cable
-Replace winding