Villager VLS8T-01S Mode D'emploi page 26

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

according to the described method.
3. Protective arches (26) on both
Handle guard are always
assembled using 2 bolts with cross
groove (27).
2.Table assembly
Depending o the split wood length, the table
board can be fixed in three heights - 580mm,
770mm and 1060mm, insert the table board to
the required holders (28). Secure the table
board by the locking lever (29) on both sides,
table locking levers are fixed in every
assembly position.
3.Lift adjusting
The working output can be increased for wood
pieces smaller than app.50cm and for more
wood pieces by shorting the backward
movement of the splitting knife.
Put a short piece of wood on the splitter table
and move the splitting knife as low as app.2
cm above the wood , switch the splitter off(red
button on the switch and disconnect the plug).
You can shorten the backward movement
using the fixed rod (31) by fixing the rod in the
required height with the adjusting screw (30)
Stand assembly
NOTE: Before Using the Machine, Please drill
2 holes (Ø12mm) on the rigid ground, the
distance of two holes is 20 cm. Fix the
machine by insert the Bolts (M8X110) into the
two holes of the Bottom of the stand and holes
on the ground.
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bg pro vls 8t-16

Table des Matières