Aliaxis Nicoll WBS1PMU Notice De Pose page 28

INSTALLING THE SUPPORT FRAME
INSTALLATION WITH PUSH BUTTON 403L / 404L / 405L
Don't forget to plan an
!
access hatch in case of any
maintenance operations.
The tiling thickness must NOT exceed 35 mm or 90 mm if you are using the
extension.
If implementation in hollow wall, don't forget to add shim.
PROTECTION OF THE RODS & PIPES
Install the threaded rod protections
(protective ringed tubes) and plugs.
This system offers you a large number of personalized finish choices and the tiling
structure can be completed with many solutions:
- with square plaster panels, bricks, etc.
- with marine fiberboard panels
- with 2 superposed waterproof BA13 plates
- with 1 waterproof BA18 plate
The tiling is installed from page 24 to 25 of the installation guide.
28
Ø 40 mm
680 mm
Plan a 40 mm diameter hole to
install the push button.