Connecting The Water Inlet - Aliaxis Nicoll WBS1PMU Notice De Pose

INSTALLING THE SUPPORT FRAME

CONNECTING THE WATER INLET

It is recommended to connect the
water inlet directly to the stop cock. If
a flexible tube is used (not supplied),
the two fittings at both extemities of the
flexible tube must be installed inside
INSULATING
the cistern for safety in case of a leak.
FOAM
The water inlet can be installed to the
left or to the right of the cistern by
breaking the feed hole's protective
washer (note: factory mounted for
a left side water inlet). Refer to the
maintenance operations to see how to
change the float valve for a right side
water inlet installation.
Bleeding the water feeding pipe:
Remove the float valve by pulling on
the tab and then lifting the float valve
and its support.
Bleed to evacuate impurities. Make
sure the water inlet is sealed correctly
to prevent leaking and reinstall the float
valve.
It is recommended to test the complete assembly (with the pan and connectors) to
make sure it is leak-proof before installing the tiling (replace the paneling between
the frame and the pan by wedges).
Carry out a few complete toilet cistern filling and flushing cycles.
26