Technical Data; Installation - Electrolux IK3030Z Notice D'utilisation

Problem
The temperature in the
appliance is too low/high.
The temperature in the re-
frigerator is too high.
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Press on the rear hook and at the same
time slide the lamp cover in the direction
of the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into its
original position.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the lamp
comes on.

TECHNICAL DATA

Dimension of the recess
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
Possible cause
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Height
Width
Depth
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Make sure that there is cold air cir-
culation in the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
the appliance before installing the
appliance.
electrolux 11
Solution