evenes GBK 80 D Mode D'emploi page 4

Dear buyer, thank you for purchasing our product.
Prior to the installation and first use of the electric water heater, please read
these instructions carefully.
This water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the Safety Certificate and the
Electromagnetic Compatibility Certificate. The technical characteristics of the product
are listed on the label affixed between the inlet and outlet pipes. The installation must
be carried out by qualified staff. All repairs and maintenance work within the water
heater, e.g. lime removal or inspection/replacement of the protective anticorrosion
anode, must be carried out by an authorised maintenance service provider.
INSTALLATION
The water heater shall be installed as close as possible to the outlets. When installing
the water heater in a room with a bathtub or shower, take into account the
requirements defined in IEC Standard 60364-7-701 (VDE 0100, Part 701). It has to
be fitted to the wall using appropriate wall screws with a minimum diameter of 8 mm.
A wall with a poor load-bearing capacity must be properly reinforced where the heater
will be installed. The water heater may only be fixed upon the wall vertically.
A B
GBK 80 D 803 565 207 340
GBK 100 D 948 715 202 416
GBK 120 D 1103 865 207 416
GBK 150 D 1318 1065 222 416
4
C D
Connection and installation
dimensions of the water heater [mm]