Installing The Product; Installing The Remote Control - Duux Whisper Mode D'emploi

Masquer les pouces Voir aussi pour Whisper:
Table des Matières

Publicité

Keep children away from playing with the device.
Do not pull the unit along by the cord.
If the supplied power cord is damaged it must be
replaced by an electrician or qualified person to
avoid any hazard.
The mains supply must confirm to the
specification shown on the rating label on the
back of the device.
Close doors and windows for optimal efficiency.
Keep curtains or blinds closed during the
sunniest hours of the day.
Do not turn on the device if you have discovered
damage to the appliance, cord or plug or if the
device is malfunctioning or if there are signs of
any other defect. Return the complete product to
the point of purchase or to a certified electrician
for inspection and/or repair. Always ask for
original parts. The device (incl. cord and plug)
may only be opened and/or repaired by properly
authorized and qualified persons.
Only a licensed professional is allowed to
dismantle or modify the device.
This device is to be used only for its prescribed
purpose. Any other use is deemed to be a
cause of misuse. The user/operator, not the
manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
6

Installing the product

Place the mount on the base of the product,
1
slightly turn counterclockwise to lock into the
base and tighten with the locking ring on the
bottom side.
mount
base
locking ring
Place the rear grill over the motor and tighten
2
with the locking ring.
Attach the fan blades to the motor.
3
Note: make sure that the grooves in the fan
blades are slid over the pins
Use the plastic screw to secure the fan blades.
4
Note: turn the screw anticlockwise firmly to
secure it.
Fit the front grill and rotate it a little, clockwise,
5
until the arrow on the grill lines up with the
left-side marker.
CLOSE
OPEN
Fit the supplied screw to the underside of the
6
grill and connect the two halves firmly together.

Installing the remote control

1
Remove the lid
Place the battery according to the instructions
2
on the lid with the correct polarity
3
Close the lid
Note:
• Only use 1x CR2025 3V batteries
• Non-rechargeable batteries are not to be
recharged
• Exhausted batteries are to be removed from the
remote control and safely disposed of
• If the remote control is to be stored unused for a
long period, the battery should be removed
• The supply terminals are not to be short-circuited.
7

Publicité

Table des Matières
loading

Table des Matières