•
Keep children away from playing with the
device.
•
Do not pull the unit along by the cord.
•
If the supplied power cord is damaged it must
be replaced by an electrician or qualified
person to avoid any hazard.
• T he mains supply must confirm to the
specification shown on the rating label on the
back of the device.
• C lose doors and windows for optimal efficiency.
•
Keep curtains or blinds closed during the
sunniest hours of the day.
•
Do not turn on the device if you have
discovered damage to the appliance, cord
or plug or if the device is malfunctioning or if
there are signs of any other defect. Return the
complete product to the point of purchase or
to a certified electrician for inspection and/or
repair. Always ask for original parts. The device
(incl. cord and plug) may only be opened and/or
repaired by properly authorized and qualified
persons.
•
Only a licensed professional is allowed to
dismantle or modify the device.
•
This device is to be used only for its prescribed
purpose. Any other use is deemed to be a
cause of misuse. The user/operator, not the
manufacturer will be liable for any damage or
injuries of any kind caused as a result of this
6
Installing the product
Install and secure rear grill: Place the rear grill
1
over the motor and tighten with the locking
ring.
Install fan blade: Place the fan blade on the
2
motor.
Note: Make sure the pins on the motor axis
align with the groove on the fan blade
Secure fan blade: Use the plastic nut
3
to secure the fan blade to the motor.
Install front grill: Place the front grill on the
4
back grill. While doing so, make sure to align
arrow on the front grill with the right-side
marker. Rotate it counter clockwise until it
aligns with the left-side marker.
Fit the supplied screw (part 6) to the underside
5
of the grill and connect the two halves firmly
together.
Assemble table fan: Attach the motor to the
6
base by fitting the two metal pins of the motor
connector to the designated holes in the base
connector.
Note: The largest of the two pins must align
with the largest of the two holes. The pins are not
identical in size to ensure proper connection in only
one orientation.
7