Operation Display - V7 UPS1DT750-1E Installation Et Utilisation

Operation Display

UPS Mode
UPS Power ON
AC Mode
Operation Display (Continued)
UPS Mode
Overload in AC mode
Battery Mode
Overload in battery mode
*NOTE: If backlight shuts off, you may activate it by touching the screen
LCD
When AVR is functioning,
icon will flash every second
LCD
icon will flash
When batter level is low.
icon will flash.
icon will flash
Description
When UPS is powered on, it will enter this mode for
4 seconds
LCD information will be displayed in the following
order when LCD is touched.
1. Output voltage
2. Input voltage
3. Load Level
4. Battery capacity
Description
When overload occurs, alarm will beep every 0.5
seconds
Alarm will beep every 10 seconds and LCD
information will be displayed in the following order
when LCD is touched
1. Output voltage
2. Input voltage
3. Load Level
4. Battery capacity
When overload occurs, alarm will beep every 0.5
seconds
www.V7world.com