Until you get used to the settings, use the
following as a guide. For best results, start
cooking at the high setting; then turn the
control knob down to continue cooking.
SETTING
RECOMMENDED USE
•
HI
To start foods cooking.
or
•
To bring liquids to a boil.
MAX
Medium-high
•
To hold a rapid boil.
•
or
To fry chicken or pan-
6-8
cakes.
Medium
•
For gravy, pudding, and
(opposite OFF)
icing.
or
•
To cook large amounts of
5
vegetables.
•
Medium-low
To keep food cooking
or
after starting it on a higher
2-4
setting.
LO
•
To keep food warm until
or
ready to serve.
1
Simmer element
Models IBC310 and WBC310: The right
rear element can maintain lower tempera-
tures for preparation of foods which require
very low heat.
Cookware tips
•
Select a pan that is about the same size
as the surface unit.
• NOTE:
For best results and greater
energy efficiency, use only flat-bottomed
cookware that makes good contact with
the surface units. Cookware with rounded,
warped, ribbed (such as some porcelain
enamelware), or dented bottoms could
cause severe overheating, which damages
the cookware and/or surface unit.
You can, however, use the newer
cookware available with slightly indented
bottoms or very small expansion channels.
This cookware is specially designed to
provide the good contact needed for best
cooking results.
U SIN G Y OU R C OO K TO P
Also, woks, canners, and teakettles with
flat bottoms suitable for use on your
cooktop are now available in most stores
that sell housewares.
•
The pan should have straight sides and a
tight-fitting lid.
•
Choose medium to heavy gauge (thick-
ness) pans that are fairly lightweight.
•
The pan material (metal or glass) affects
how fast heat transfers from the surface
unit through the pan material and how
evenly heat spreads over the pan bottom.
Choose pans that provide the best cooking
results.
•
Handles should be made of sturdy, heat-
resistant material and be securely attached
to the pan.
NOTES:
•
If a surface unit stays red for a long time,
the bottom of the pan is not flat enough or
is too small for the surface unit. Prolonged
usage of incorrect utensils could result in
damage to the surface unit, cooktop,
wiring, and surrounding areas. To prevent
damage, use correct utensils, start cooking
on HI, and turn control down to continue
cooking.
•
Do not leave an empty utensil, or one
which has boiled dry, on a hot surface unit.
The utensil could overheat and damage
the utensil or surface unit.
7