Bticino 391415 Guide D'instructions Rapide page 36

391 415 - 391 416
2. Connection under various signal input mode
a. Connecting with DVR
• Make sure the MONITOR set and DVR have been turned off.
• Connect the AV BNC input jacks of the monitor set to correspondingly signal output interface of the DVR.
• Plug the male end of the AC adaptor to the MONITOR set and another end to the 100~240V 50/60Hz AC
power source.
• Switch on the MONITOR set by pressing "POWER" button and then the DVR.
• Press the "SELECT" button on the front control or "SOURCE" button on the remote control to switch to C-Video1
or C-Video 2/Decoder input mode.
b. Connecting with computer
You can enjoy high-definition interface and sounds once you connect the MONITOR set to computer.
• Make sure the monitor set and computer main unit have been turned off
• Connect the D-SUB 15 pin VGA plug of the unit to the computer's
• Plug the male end of the AC adaptor to the MONITOR set and another end to the 100~240V 50/60Hz AC
power source.
• Switch on the monitor set by pressing "power" button and then computer.
• Press the "SELECT" button on the front control or " Source" button on the remote control to switch to RGB
input mode.
36