Technical Data - BorMann Pro BDH4800 Manuel D'instruction

EN

Technical Data

● Power: 1500W
● Impact Rate: 50 Joule
● HEX size: 30mm
● Weight: 14,2Kg
Description of main parts
Retainer
Front cover
Operating instructions
Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which specified on the name plate of the hammer.
2. Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the power switch is in ON position, the demolition
hammer will start operation immediately, which could cause a serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as
short as practicable.
Switch operation
Observe correct mains voltage! The voltage of the power source must agree with the voltage specified on the type
plate of the power tool.
Switch on: Press the switch towards I position.
Switch off: Release the switch towards O position.
For low temperatures, the machine reaches the full impact rate only after a certain time.
This start-up time can be shortened by striking the chisel in the power tool against the floor one time.
Shock absorption Equipment
The tool is equipped with an active vibration reduction system, which greatly reduces the vibration generated by
the device. This may significantly reduce the exposure level over the total working period. Thus, this system
protects the operator from the effects of vibration.
3
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these
changes significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you
hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be included in the
product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including
maintenance and special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or
even serious injury or death. The manufacturer and the importer shall not be liable for injuries and damages resulting from the use of
non-conforming equipment.
Aluminum head
WWW.NIKOLAOUTOOLS.GR
Side Handle
Encloser
Fan cover
Switch
Main Handle
Switch