After Installation; Technical Information - LUCCI Air Mariner Guide D'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Mariner Installation Instructions

WOBBLE:

NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the

fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite

acceptable and DOES NOT suggest any problem.

TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down rod are

secure.

BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the

instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing should the ceiling

fan become un-balanced again. Store your balancing kit away after installation for future use if required.

NOISE:

When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and

frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in

fan motor noise. This is normal. Please allow a 24-hour "breaking-in" period, most noises associated with

a new fan disappear during this time. All electric motors are audible to some extent. Please note that this

is not a product fault, and as such is not coverd under warranty.

CARE AND CLEANING:



Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free

cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.



Do not immerse your ceiling fan in the water. It could damage the motor or the blades and create the

possibility of an electrical shock.



Ensure that the fitting does not come in contact with any organic solvents or cleaners.



To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.



The motor has a permanently lubricated ball bearing so there is no need to oil.

NOTE: Always turn OFF the power at the mains switch before attempting to clean your fan.

Ceiling Fan model

Mariner fan without light

Mariner fan with light

12 | P a g e