Introduction; Cable Connection; Electrical Connection - Asco MOTORFLOW D 610 Série Manuel D'installation

INSTALLATION
1.

INTRODUCTION

D
The M F is a motorised control valve designed to control the flow of liquids.
OTOR LOw
A DC motor controls the opening width to regulate the flow. A potentiometer is integrated into the electrical actuator to
capture the position. A microcontroller enables digital control. Two buttons are provided for manual control. The setpoint
is displayed in % (0-100%).
A PC software and the RS232 interface allows modification of settings and parameters and data recording.
The position is maintained on loss of power. The actuator remains in its current position.
2. CABLE CONNECTIONS
M12 male connector
(power supply:
setpoint/feedback)
RS232 interface
M12 female connector
(external sensor)
3.

ELECTRICAL CONNECTION

Male connector pinning (power supply)
+ 24 V DC, supply
analog setpoint input
supply ground
(1)
analog ground
analog output (feedback)
digital output (pressure switch)
EMC shield
(1)
A 6-wire cable with separate analog ground is used for cable lengths over 2 m to set off the voltage drop for the setpoint.
(2)
The housing of the M12 male connector/M12 female connector is connected to the valve body.
Cover
M12
4
3
5-wire cable
5
(2 m)
1 2
brown
1
white
2
blue
3
black
4
grey
5
(2) shield
Housing
Female connector pinning (sensor)
6-wire cable
(5 m, 10 m)
brown
+ 24 V DC, supply
white
external feedback input
green
supply ground
yellow
frequency input
pink
grey
EMC shield
shield
All leaflets are available on: www.asconumatics.eu
GB
LEDS
Display
Buttons
M12
1 2
5
4 3
1
2
3
4
unused 5
(2)
Housing
IM14219-3