Weber Clean Track NANOscrub Manuel D'instructions page 37

6.3 BATTERY CHARGER CONFIGURATION
• We recommend to call the assistance centre or
a technician if you have problems with the setting
given.
The machine is equipped with a battery charger
configurated for OPTIMA maintenance free
battery.
If the operator whish to use Pb-Acid battery or
GEL/AGM battery, it is necessary to change the
battery charger settings as follows:
• DISPLAY OF THE BATTERY CHARGER SETTINGS
The battery charger settings are shown by the
blinking of the LED indicator when the battery
charger is switching on:
- the RED LED indicator ( Photo 17 - B )
flashes 2 times = the battery charger is set for
PB-Acid batteries
- the GREEN LED indicator ( Photo 17 - C )
flashes 2 times = the battery charger is set for
B
A
Photo 17
Table A
Tipo di
batteria
Pb-Acido
Gel / AGM
Optima
6 - INSTALLATION INFORMATIONS
E
SW1
Dip-Switch 1 Dip-Switch 2 Dip-Switch 1 Dip-Switch 2
OFF ON
OFF OFF
OFF ON
GEL/AGM or OPTIMA batteries
The battery charger settings will be displayed even
if the battery is not connected.
• DIP-SWITCH CONFIGURATION FOR CHARGING
CURVE SETTINGS FOR BATTERY CHARGER CBHD1
12V 6A
To set the charging curve type for Pb-Acid, GEL/
AGM or OPTIMA batteries it is necessary to op-
erate on the dip-switches placed inside the
battery charger ( Photo 17 - D ) ( Photo 17
- F ).
To access the dip-switches it is necessary to re-
move the lower panel of the battery charger (
Photo 17 - A ); it is also possible to reach the dip-
switches by removing the plastic cap ( Photo 17
- E ).
To configurate the charging curve related to the
different battery type it is necessary to set the dip-
switches as indicated in the Table A here below:
A) Battery charger cover
B) Red "LED" - Battery discharged
C
C) Green "LED" - Battery charged
D) Dip-Switches
E) Plastic cap
F) Dip-Switches for charging curve
setting
SW1 SW2
F
SW2
ON
OFF
OFF
37
SW 1 SW 2
ON ON
ON
OFF OFF OFF
DIP 1
DIP 1 DIP 2
ON
ON
OFF
ON
OFF
OFF
DIP 2