Weber Clean Track NANOscrub Manuel D'instructions page 36

6.2 BATTERY INSTALLATION
The battery compartment is placed in the solution
tank ( Photo 14 ) and to access it is necessary to
remove the recovery tank; to remove the recov-
ery tank, detatch the suction hose from its siege
( Photo 4 - B ) and lift the tank by pulling it up as
shown in Photo 13.
Place the battery in the battery compartment
(Photo 14) checking that it is in perfect conditions.
6.2.1 BATTERY CONNECTION
• Attach the battery wiring to the battery,
connecting the terminals only on the poles
marked with the same symbol (red wiring
"+", black wiring "-") as shown in the con-
nection diagram in Photo 15.
A battery short-circuit may cause an explo-
sion!
After checking that all the controls on the panel are
in position "0" or at rest, connect the battery con-
nector to the machine connector ( Photo 16 - B ).
Photo 16 shows the correct battery connection.
• Close the battery compartment replacing the
recovery tank, making sure not to crush any wire.
A
D
C
Photo 16
6 - INSTALLATION INFORMATIONS
B
Photo 13
Photo 14
Photo 15
A) 12V Battery with cabling
B) Battery connector
C) Suction motor thermal breaker
D) Traction motor thermal breaker
36