Finishing The Installation; Changing The Batteries - LEGRAND Qmotion QLink Mode D'emploi

Activate and Program Shade
Your shade has factory preset position settings. To activate the shade and set a new Down position:
1. Tug hem bar downward at least 18-20 inches to start the activation process. Perform step 2
within 1 minute or shade deactivates and returns to Up position automatically.
2. Press and hold UP button for approximately 5 seconds until shade begins to move up. Wait for
shade to stop in Up position. This remote is now learned to the shade.
3. Press DOWN button to send shade to the factory default Down position. To reprogram this Down
position, follow steps 4 through 7.
4. While shade is in factory preset Down position, press and hold DOWN button for approximately
5 seconds. Shade will move up slightly, then back down slightly and stop. Release the DOWN
button.
5. Pull the hem bar to the desired Down position. The shade is now in Down Position Learn Mode.
6. When satisfied with Down position, press and hold the DOWN button for approximately 5
seconds until shade begins to move up. The shade is no longer in Down Position Learn Mode.
7. The shade will continue to move up until it reaches the brackets. After shade stops it is
programmed and ready to use.
Height and Depth Adjustments
If the shade edges are not parallel, either up and down or in
distance from the wall, the two nuts on the coupler assembly that
secure it to the bracket can be adjusted.
For height adjustment, if the gap widens at the bottom, adjust
the Coupler Assembly upward. If the gap closes at the bottom,
adjust the Coupler Assembly downward.
Adjust Coupler Assembly height as needed using 3/8" or 10mm
wrench. Couplers are set to nominal at factory. If more adjustment
is needed, moving brackets up or down may be necessary. Initial
leveling is critical.
Turning left adjusts the Coupler Assembly downward. Turning right
adjusts the Coupler Assembly upward.
For depth adjustment (distance from wall), adjust as needed using
3/8" or 10mm wrench.
Turning left adjusts the Coupler Assembly toward the wall. Turning
right adjusts the Coupler Assembly into the room.
NOTE: Both adjustment nuts may be adjusted 2.5 turns up or 2.5
turns down from nominal.

Finishing the Installation

Ensure that all safety straps are installed on all coupler brackets. Ensure that all coupler
Lock Rings are tightened securely.

Changing the Batteries

1. Using the remote, move the shade to the Down position. If the shade's
batteries are completely depleted, you may skip to step 3.
2. Tug the shade past the Down position. The shade will then automatically
reverse direction and move to the 75% position.
3. Carefully pull the hem bar down in one continuous motion until the
battery window is exposed. Ensure Manual Operation is deactivated by
tugging the shade or turning the tube. If deactivated, remove the battery
cover to expose battery access. Use a screwdriver to move batteries
down to the opening.
4. Replace all batteries with fresh D-Cell alkaline batteries. Always use the
same brand and manufacturing date. Orient all batteries with the positive
end as shown.
5. Reinstall the battery cover flush with the shade tube. Press any button.
The shade moves to the Up position. The shade will now resume normal
operation. All positions are recovered from memory
2.5
Threads
Coupler Assembly
Adjustment Nut
Nominal Position
5
80%
60%
40%
20%
CH
1 3 2 4 5
Height Adjustment
Depth Adjustment