LEGRAND Qmotion QLink Mode D'emploi page 4

E. Install Safety Strap onto Coupler Bracket
Install end of strap without screw hole into the slot in the coupler bracket, then secure strap to bracket with screw.
WARNING! You must install the safety straps on all coupler brackets one at a time in succession during the installation process to
reduce the risks of personal injury and possible damage to the shade.
Do not wait until the end to install safety straps.
F. Install Inner Shade onto secured Coupler Assembly
If there is no inner shade advance to step H.
Coupler
Assembly
The roller tube is designed to guide the couple cone into position,
although long shades may require two people to install safely.
Inner Shade
Align all shades to couplers the same way, always aligning hem
bars in the up position. Unroll or roll up connecting shades to
align hem bars.
Fine adjustments can be made later. (See Height and Depth
Adjustments.)
G. Repeat Previous Steps if needed
For each additional inner shade and for the motorized shade,
Align
repeat steps B through F.
H. Insert Motorized Shade spindle into End Bracket
End Bracket
Spindle
Adjust Hembars and Tighten the Lock Ring
Starting at the Sprung Shade and moving left, adjust the hem bars
to match each previous shade by holding the shade on your right
with your right hand and the shade on your left with your left hand
and rotating the left shade to match the shade on the right. Use
the supplied Spanner Wrench to tighten Lock Ring once the hem
bar is located at the desired position. Tighten the Lock Ring by
turning the Spanner Wrench up. Loosen the Lock Ring buy turning
the Spanner Wrench down.
4