LEGRAND Qmotion QLink Mode D'emploi page 3

A. Insert Sprung Shade spindle into End Bracket
NOTE: Prewinds are made on the Sprung End.
C. Rotate Coupler Assembly into Coupler Bracket
Ensure coupler disk nut is completely engaged into
circular bracket plate.
B. Insert Coupler Assembly into Sprung Shade
End Bracket
Spindle
D. Secure Coupler Assembly to Coupler Bracket
Install screw into the Coupler Assembly, through the hole in the
Coupler Bracket's arm.
Ensure that the Oblong Shoulder rests aligned in the slot, as shown
in the bottom view below.
3
Oblong Shoulder
Correctly
Installed
Bottom view
(either direction)
of slot in
bracket
Incorrectly Installed