Overview - Dogtra RB1000 Serie Notice D'utilisation

OVERVIEW

The Dogtra RB 1000 Series has a remote beeper with
three different modes. The LCD screen will display
the mode on the front of the transmitter. To activate
the transmitter, press and hold the blue button on the
right side of the transmitter until both the LCD and LED
window illuminates. Next, hold the two red dots on the
transmitter and receiver together until the receiver light
starts blinking. The receiver/collar's LED window will
blink green every 4 seconds to show that the unit is on
and fully charged.
The Dogtra RB 1000 Series has three beeper modes:
Run/ Point, Point-Only, and Locate. Locate is available
anytime by pressing the top orange button on the left
side of the transmitter. To activate the other beeper
modes, press the Run/Point button or Point button on
the front of the transmitter . In the Run/Point mode,
it will double beep every 7 seconds while the dog
is running. While the dog is on point or stationary it
double beeps every 2 seconds. In the Point-Only mode,
the unit will not beep while the dog is moving (you can
use the Locate mode for locating your dog). When the
dog points or becomes stationary, the unit will emit a
double beep every 2 seconds.
Orange Collar : double beep,
Green Collar : single beep
44
The Locate feature can be used at any time, it will beep
as long as you press and hold the button (for up to 12
seconds). Remember, the Locate button can still be used
at any time!!
The Dogtra RB 1000 Series has four different sounds. It
can be selected by pressing the Sound button below the
Locate button on the left side of the transmitter .
The Dogtra RB 1000 Series is also available for the two-
dog model. The collars are color-coded (orange and
green) you can select between the two collars with a
toggle switch located on the transmitter.
The orange collar emits a double beep in all modes and
the green collar emits a single beep in all modes. This
gives you the ability to differentiate between dogs when
both are out of sight.
45