Publicité
Les langues disponibles
Les langues disponibles
Volkswagen Caddy + Seat Inca
1996 - ....
Ref. 0159
Fitting instructions
1)
Remove the spare wheel. Remove the two bolts that attach the bumper supports to the chassis.
2)
Make an incision in the middle of the bumper, 3cm deep, measured from the bottom, and 14cm wide.
3)
Place the tow bar with points (A) fitting the free screw-thread holes mentioned in point 1. Reinsert the bolts. Point (B)
fits the provided drilling in the side of the chassis beam. Points (C) have to be drilled in the side of the chassis
beams.
4)
Place mounting pieces (e) and (f) in the chassis through the covered slots. Place the mounting pieces so that points
(B) and (C) of the mounting pieces fit those of the tow bar. Insert the necessary bolts and washers.
5)
Install the (*) and tighten everything firmly.
6)
Reinstall the rubbers in the slots and also reinstall the spare wheel at its original place.
Composition
1 tow bar reference 0159
1 ball T43K004
4 bolts M12x40
1 socket plateP03
4 bolts M10x30
1 mounting piece (e)
1 mounting piece (f)
4 safety washers M10
4 safety washers M12
1
security shackle
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*)
(*)
(B-C)
(B-C)
(C)
(B-C)
(*)
(*)
All bolts and nuts : quality 8.8
Publicité
