Platinum CM4605T Mode D'emploi page 9

ENGLISH
CLEANING MINERAL DEPOSITS (for the section of making espresso coffee)
1. To make sure your coffee maker operates efficiently, internal piping is clean and you get the
maximum flavor in your coffee, you should clean away the mineral deposits every 2-3 months.
2. Fill the tank with water and descaler to the MAX level (the ratio of water and descaler is 4:1, the
detail refers to the instruction of descaler. Please use "household descaler", you can use the citric
acid (obtainable from chemist's or drug stores) instead of the descaler (the one hundred parts of
water and three parts of citric acid).
3. According to the program of pre-heating, put the metal funnel (no coffee powder in it) and carafe
(jug) in place. Brew water per "PRE-HEATING".
4. Press down ON/OFF button for espresso coffee, the yellow indicator will be illuminated, you
should press the pump control switch, press the
water flowing out and close the pump, and wait for a moment, the coffee maker begins to be
heated.
5. When the green lamp is illuminated, it shows the heating is finished. Press the pump control
button to the "P" position and make two cups coffee (about 2Oz). Then close the pump and wait
for 5s.
6. Press the /
steam for 2min, then turn the steam controller to the off position to stop making steam. Press the
ON/OFF II to the "0" position to stop the unit immediately, leave the descalers deposit in the unit
at least 15 minutes.
7. Restart the unit and repeat steps 4-6 at least 3 times.
8. Then pressing the
pump control button to "P" position to brew until no descaler is left.
9. Then brew coffee (with no coffee powder) with tap water, at the MAX level, and repeat steps 4 to
6 3 times (it is not necessary to wait for 15 minutes in step 6), and then brew until no water is left
in the tank.
10. Repeat step 9 at least 3 times to make sure the piping is clean.
CLEANING MINERAL DEPOSITS (for the section on making drip coffee)
1. Fill the tank with water and descaler to the MAX level (the ratio of water to descaler is 4:1), the
detail refers to the instructions of the descaler. Please use "household descaler", you may use
citric acid instead of the descaler (one hundred parts of water and three parts of citric acid).
2. Push carafe onto keeping warm plate, pay attention to ensure that the center line of the carafe
aligns with that of the brew basket.
3. Press down the ON/OFF button, and the indicator will be illuminated. After a while, water will drop
out automatically.
4. After percolating the equivalent of one cup, press the ON/OFF button again to stop the appliance.
5. Allow the solution to work for 15 minutes, repeat steps 3-5 again.
6. Turn the appliance on and run off the water until the water tank is completely empty.
7. Rinse by operating the appliance with water at least 3 times.
button to the position, waiting until the green indicator light turns on. Make
/ button to
/ button to the
position, when the green lamp is illuminated, press the
position, when there is
8