Care And Cleaning - Platinum CM4605T Mode D'emploi

ENGLISH
Note1: after making frothed milk, remember to clean the steam tube to prevent it from being jammed
at the next use., The cleaning method is as follows: First, press the espresso coffee/frothing to select
button to position and dip the steam tube into a cup; Second, turn on the steam controller and press
the pump control button to the P position, and there will be water flowing out from the steam tube and
funnel.
Note2: after making steam for each time, we recommend you allow the maker to cool down at least
for 5 min before making coffee again. Otherwise your Espresso coffee may acquire a burnt odor, but
if you want to make coffee immediately, follow the next steps: First, press the espresso
coffee/frothing to select button to position and dip the steam tube into a cup; Second, turn on the
steam controller and press the pump control button to the P position, and there will be water flowing
out from steam tube and funnel; after the green lamp is turned off, close the pump, then turn the
steam controller to the off position. When the green lamp is illuminated, you can start to brew coffee
again.
8. Press the ON/OFF button once to cut off the power source.
PRODUCING STEAM TO HEAT LIQUIDS OR FROTH MILK SEPARATELY
The steam tube can be used to froth milk separately and make hot beverages like drinking chocolate,
water or tea.
Method:
1. Open the tank cover, add drinking water to the water tank according to the gauge.
2. Close the water tank cover, then connect the appliance to power outlet.
3. Make sure that the steam control knob is in the off position.
4. Press down the ON/OFF button, and the yellow indicator will be illuminated, you should press
the pump controller, when there is water flowing out and close the pump, the internal heat
element starts working, the coffee maker begins to be pre-heated.
5. Press down the
pre-heating is finished.
6. Dip the steam tube into the liquid to be heated or the intended froth milk. Turn the steam controller
counter-clockwise slowly to start making steam.
7. When the required temperature is reached (the ideal is 60ºC) or the frothing milk is obtained, you
can turn the steam controller to the off position.
8. Press the ON/OFF button once to cut off the power supply.

CARE AND CLEANING

1. Cut off the power supply and let the coffee maker cool down completely before cleaning.
2. Clean housing of coffee maker with a moisture-proof sponge often.
Note: Do not clean with alcohol or a solvent cleanser. Never immerse the housing in water for
cleaning.
3. Detach the metal funnel by turning it clockwise, get rid of any coffee residue inside, then you can
clean it with a cleanser, but at the end you must rinse it with clear water.
4. Clean all the detachable attachments with water and dry them thoroughly.
/ button, waiting until the green indicator is illuminated, it shows that the
7