Platinum CM4605T Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
1. Pour 1500ml water into water tank, and then replace its cover.
2. Set nylon funnel in the funnel support (add no coffee ground). Place a paper filter in the funnel.
3. Set steel mesh into metal funnel (no coffee in steel mesh). Pull the press bar backward, make
sure the tube on the funnel aligns with groove in the appliance, then insert the funnel into the
appliance from the "Insert" position and release the press bar, and you can fix them into coffee
maker firmly through turning it counter-clockwise until it is in the "lock" position.
4. Place carafe on keeping warm plate and put jug (your cup) on removable shelf.
5. Plug the power cord into the outlet, press down the ON/OFF button, the indicator will be
illuminated. The appliance will begin working. You may stop brewing by pressing the button to 0
position at any time, the indicator will turn off. The appliance will continue brewing once pressing
ON/OFF button again.
6. Press down ON/OFF for espresso coffee, the yellow indicator is illuminated, you should press
the pump control button, when there is water flowing out and close the pump button, the internal
heat element starts working, the coffee maker begins to be pre-heated. When the green is
illuminated, the pre-heating is finished. Press the pump control button again and water will flow
out.
7. When water is not dripping out any more, you can pour the water in each container out, and then
clean them thoroughly, now you can start brewing.
Note: There may be noise when pumping the water the first time, which is normal, for the appliance is
releasing the air in the appliance. After about 20s, the noise will disappear.
TO USE YOUR COFFEE MAKER
MAKE DRIP COFFEE
1. Open the tank cover, pour proper amount of drinking water into water tank according to the gauge.
Then close the tank cover.
2. Open the top cover and place the funnel into the funnel support. Make sure it is assembled
correctly. Put the filter in correctly.
3. Add coffee powder into the filter with a measuring spoon. A spoon of coffee powder can make a
cup of top-grade coffee, but you can adjust according to your taste. Close the top cover.
4. Insert the carafe on keeping warm plate horizontally.
5. Plug the power cord into the outlet, press down ON/OFF button, the indicator will be illuminated.
The appliance will begin working. You may stop brewing by pressing the ON/OFF button again at
any time.
Note: At any time, you can take out carafe to serve, but the time cannot exceed 30 seconds.
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6960467

Table des Matières