Oras Electra 6110 Guide D'installation Et D'entretien page 14

Cleaning the filter and the aerator
If the water flow has decreased, this may be because the filter is clogged. Clean the filter as follows:
Cleaning the filter
6110 (see Figures 1 and 3)
– Shut off the water supply to the faucet.
– Remove the connecting hose (7) from the control box.
– Unscrew the connecting nipple (8) and remove the strainer from the nipple.
– Clean the strainer under running water.
– Reassemble the parts.
6114 (see Figure 5)
– Shut off the water supply to the faucet.
– Unscrew the nipples (8) from the valve housing and clean or change the strainer (18)
– Reassemble the parts.
Cleaning the aerator (see Figure 6)
– Unscrew the aerator (30) with a special key (31).
– Clean the strainer under running water and replace if necessary.
Changing the temperature regulator (see Figure 7)
Troubleshooting
Symptom
Water flow from the outlet
does not stop, or stops
after 2 minutes
Water flow is low and weak
No water comes out of the faucet
14 (52)
Cause / Solution
– The sensing range is too low
– Check that the photocell is clean
– The solenoid valve is damaged
– The filter or aerator is clogged
– Check the water supply to the control box
– The solenoid valve is damaged
– Power failure
– The sensor is covered or damaged
– Check the fuse (17) inside the control box: 0.1 A