Removing And Changing The Gas Cartridge; Setting The Right Flammable Mixture; Connecting The Foot Switch; Removing And Attaching The Burner Head - Argos Technologies StarFireXT Mode D'emploi

Getting Started

Removing and changing the gas cartridge

WARNING
Do not remove or replace the gas cartridge unless the gas adapter is connected to the
device and shut off (by turning the black knob in the "OFF" direction until it stops)
The CV 360 gas cartridge is removed and changed as follows:
• The gas adapter should be attached to StarFire XT
• Turn the black knob in the "OFF" direction until the gas is shut off
• Pull the gas cartridge away from the gas adapter (towards the front of the device)
• Push a new gas cartridge into place (see "connecting the gas cartridge" above)
• Fully rotate the knob in the "ON" direction to allow gas to flow.
NOTE
i
When pulling the cartridge from the adapter small amounts of gas may leak out but are
not considered dangerous.

Setting the right flammable mixture

You can adjust the size of the flame by rotating the GAS KNOB on the front of the unit.
Rotating the knob reduces the gas supply and lowers the flame while turning counter
clockwise increases the gas and increases the flame.
You can adjust the flame temperature by rotating the AIR KNOB on the front of the
unit. Rotating the knob reduces the air supply and lowers the flame temperature while
turning counter clockwise increases the air supply and increases the flame temperature.

Connecting the foot switch

The footswitch is an optional accessory (see "Accessories and Spare Parts" on page 21)
• Insert the jack of the footswitch in the socket on the back of the device
(see page 8 for details)
• The foot switch is now connected and can be used to ignite the flame

Removing and attaching the burner head

• Pull the burner head up vertically to remove from base unit
• To reinstall, align the three contact pins with the proper holes and push gently straight
down until it clicks in place
CAUTION
STOP
Do not lift or transport the StarFire XT by the burner head.
CAUTION
After using StarFire XT the burner head will be extremely hot, wait for this to cool
down before removing the burner head.
Argos Technologies StarFire XT — Operator's Manual
(cont.)
12