MB35
2.4 Connecting to a Power Supply
Check to ensure the voltage identification label on the Moisture Analyzer matches your local line
voltage.
The halogen dryer unit is designed to operate at a specific line voltage (120 V ac or 240 V ac).
CAUTION:
Connection to line voltages that are above or below the rated voltage can cause improper opera-
tion or damage to the unit.
Allow the Moisture Analyzer to warm up for at least 30 minutes to stabilize when turned on.
WARNING:
If the power cable supplied is not long enough, use only a proper 3-pin extension cable with
an equipment grounding connector.
Connect power cord as shown. The MB35 is operational when power is applied.
The display remains off until the On/Off button is pressed.
EN-5