Kohler K-15888 Guide D'installation page 5

Faucet Shank
Nut
Supply
Tube
Supply Stop
3. Install the Supplies
NOTE: If the supply tubes need to be cut, allow for required
penetration of the tube into the supply stop.
For ground joint connections:
Slip the nut onto the supply tube.
Position the round end of the supply tube squarely to the inlet of
the faucet shank and supply stop.
Tighten all nuts.
4. Installation Checkout
Ensure that both faucet handles are turned off. Hot is clockwise
close and cold is counterclockwise close.
Turn on the hot and cold water supplies.
Check for leaks.
Remove the aerator from the spout by turning it
counterclockwise.
Turn on the hot and cold faucet handles.
Run the water for about one minute to remove any debris.
Turn off the hot and cold faucet handles.
Reinstall the aerator by turning it clockwise until hand tight.
Kohler Co.
Aerator
5 1011143-2-AB