Regulation (Digital Controller); Working Modes - Polytropic NEO INVERTER Manuel D'instructions

Regulation (digital controller)

Normal display in heating mode
ON/OFF
When you switch OFF the machine on the controller, the display will indicate « Stand-by »
Button serves to start/stop the heat pump.
After stopping the machine with this button, it can take a few minutes till the machine comes to a complete hold.

Working modes

Button serves to change the working mode.
By pressing this button, the icon corresponding to the selected mode will appear:
•
•
+
•
+
•
+
•
+
•
+
•
+
Time setting
•
Keep key pressed for 3 seconds (hours will blink)
•
Set hours with
Buttons below the display
"Smart" heating and cooling mode: machine manage it's power for best efficiency.
Heats the water up to the desired value (+/– 1°C)*.
"Eco" Heating mode: the machine manage its power and keep low noise / low speed
Heats the water up to the desired value (+/– 1°C)*.
"Smart" Heating mode: machine manage it's power for best efficiency.
Heats the water up to the desired value (+/– 1°C)*.
"Boost" Heating mode: the machine manage its power and keep high power.
Heats the water up to the desired value (+/– 1°C)*.
"Eco" Cooling mode: the machine manage its power and keep low noise / low speed
Heats the water up to the desired value (+/– 1°C)*.
"Smart" Cooling mode: machine manage it's power for best efficiency.
Heats the water up to the desired value (+/– 1°C)*.
"Boost" Cooling mode: the machine manage its power and keep high power.
Cools the water down to the desired value (+/– 1°C)*.
or .
All icons available
- 23 -