Storage, Shipping And Packing; Standards; Utilization Limits - Polytropic NEO INVERTER Manuel D'instructions

Storage, shipping and packing

Appliance must be packed and stored vertically, as specified on the packing.
A horizontal storage, even if temporary, will damage the appliance.
All damage due to incorrect packing or storage,will not be taken under warranty.
NeoInverter rencourages its customers to keep the heat pump packaging (paperboard pack + polystyrene + pallet)
for the duration of the warranty period in case of a need to return the appliance to the factory.

Standards

CE standard conformity
NeoInverter pool heat pumps meet the following standards:
•
Electromagnetic compatibility:
•
Safety requirements for low voltage equipment:
•
Pressure Equipment:
•
Noise production:
•
Harmonized standards:
•
Electrical connections
•
French standard installation reference:
Safety
Although this product contains all safety requirements, it may still present dangers such as:
Electrically controlled parts
Parts moving with automatic start-up (fan)
Cutting edges (evaporator)
In order to avoid accidents, prevent close access the appliance by children and pets. Never cover the
appliance whilst in operation and never put your fingers, or other objects inside.
Never turn on the appliance with any of its panels removed.
Pressure controller
NeoInverter heat pumps are provided with HP pressure controller set at 38 Bar.

Utilization limits

To ensure the heat pump has been correctly sized, NeoInverter must has been previously contacted with a selection file
(available on demand) in order to validate such selection.
"Inverter" range heat pump models are designed to operate from 0°C to +35°C C (5°F to 95°F) air temperature using a
pool cover.
If the machine is used to work with an ambient temperature below 0°, particularly for high water temperatures, it is
advised to add an electrical heater (ask your seller).
Regarding product selection that has not been validated by NeoInverter and working outside the above ranges;
NeoInverter dissociates its responsibility regarding any lack of performance.
Before installing the heat pump, you will have checked that the impedance of your swimming pool electricity power
supply shall not be more than 0.042 Ω.
Ask your electricity provider if necessary.
Correct packing and storage position.
2004/108/EC
2006/95/EC
97/23/CE
200/14/CE
NF EN 60335.1,2.40
NF C 15 100.
- 18 -