DOM Easykey Instructions D'installation page 7

Functions: Easykey in use
CHANGE MASTER CODE
By default Easykey has a Master Code 856069, it is recommended to change the master
code when the digital handle is installed.
Each installation administrator-user can change it, following the sequence below:
A+A+C+C+A+A+CURRENT MASTER CODE+A+NEW MASTER CODE+A
ACTIVATE USER CODES
To enter a new code follow the sequence below:
A+C+A+MASTER CODE+A+CODE 1+A+CODE 2+A+...+CODE N+A+C
DEVICE OPENING WITH USER CODE
To open the device enter the user code followed by the letter A:
CODE+A
DEACTIVATE USER CODES
To cancel a code, follow the sequence below:
C+A+C+MASTER CODE+C+CODE 1+C+CODE 2+C...+CODE N+C+A
COMPLETE DEACTIVATION OF ALL USER CODES
To cancel / deactivate all the stored codes follow the sequence below:
C+C+A+A+C+C+MASTER CODE+C
CREATE/CHANGE FREE-ENTRANCE CODE
A+A+A+C+C+MASTER CODE+A+FREE-ENTRANCE CODE+A
ACTIVATE/DEACTIVATE FREE-ENTRANCE MODE
FREE ENTRANCE CODE+A
_easykey_installation_guide cc2017.indd 5
EN
5 5
17/07/2018 17:57:47