KIRAMI Original Breezy Mode D'emploi page 40

FIRE SAFETY
If the heater is located near buildings, for example on the
side of a terrace, the distance of the chimney from any
combustible materials must be adequate. Remember to
check the distance both laterally and vertically so that there
isn't any risk of fire. Safe minimum distance, from the
chimney's upper end, laterally is three (3) meters. Shorter
distance laterally is adequate in other parts of the chimney. If
the chimney is closer to any combustible materials you must
use special insulated chimney, which has to be purchased
separately.
When positioned close to the roof or when taken through it,
the top end of the insulated chimney must be at least one (1) meter above the surface of the roof.
Ask your local fire officer for more information.
Notice also the fire safety in front of the furnace. There shouldn't be any combustible materials in
front of the furnace. There should be an area, which is demonstrated in the picture that should be
made of incombustible material such as concrete, sand or metal.
Grates
A fire grate is installed to the heater, with one grill plate.
An air guide is installed to the top shelf which guides the fire air
circulation on the top part of the hearth. The heater must not be used
without these parts.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this
heater. The reduced end of the chimney fits inside the heater. The
chimney parts can be purchased separately in three different lengths: 25
cm, 50 cm and 100 cm. There are also available adjustable chimney
corners and 100 cm long protective sleeves for the lower part of the
chimney.
We recommend a chimney kit for the heater. This package includes
200 cm chimney + 100cm protective sleeve and a standard hat.
There are also spark protective hats available for the chimney.
If you have purchased a chimney kit with the heater. It is supplied in a
separate box and has four parts (see picture right) and it has to be
assembled.
Remove the protective film from the thermal protection and place the
assembled chimney to the chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use protective gloves!
User manual: Kirami MACU Hot tub heater
Page 6