KIRAMI Original Breezy Mode D'emploi page 37

The installation procedure varies between different barrel / tub models. Common to them all is that
you use two rubber hose pieces and hose clamps to fix the heater in its place. Using of the fixing
pieces and installation height varies.
The following is common to all installations:
•
It is advisable to spray silicon spray or other lubricant like soap inside the rubber hoses to
tighten the hose clamps evenly and to prevent the hoses from wrinkling.
•
Connection hoses are installed first on the heater pipes.
•
The heater fixing plates are always placed between the fixing plates on the tub. The
horizontal part of the heater plates keep them from bending in.
•
Check that the connection hoses are not wrinkled before tightening them.
•
To make sure that the heater is installed perpendicular to the tub. Measure the distance on
both sides (measure X in the pictures) before fixing the screws. This makes sure that the
screws will hit both plates.
•
Make sure that the heater is horizontal or leaning just a bit towards the tub. So that the
heater will become empty when emptying the tub.
Installation into different tubs is written in the following.
STEP-BY-STEP INSTRUCTIONS FOR
MOUNTING THE STOVE:
1. Attach the upper rubber tube to the stove
and tighten the stove-side hose clamp
securely.
2. Attach the lower rubber tube to the stove,
but do not tighten it yet and leave the rubber
tube closer to the edge.
3. Push the lower tube onto the tub first.
4. Then attach the upper tube.
5. When you are done, tighten all hose clamps
securely.
User manual: Kirami MACU Hot tub heater
INSTALLATION
Page 3