Dometic Fan-Tastic Vent Manuel D'installation Et D'utilisation page 5

4.3 Clamp-fan mounting
3
Sealant
(Exterior)
All Fan-tastic Vents are available in a "clamp fan" configuration . The clamp garnish screws into the fan base from
inside the RV and trims the ceiling cut-out .
I
RV mfg . clamp fans require mounting screws and correct-height garnish, predetermined by a qualified
installer and Fan-Tastic Vent .
➤ Clamp fans use a double-bead of compatible sealant between the fan base mounting flange and the roof (no
putty tape, butyl or gaskets are to be used with clamp fans) .
➤ Using the four screws provided, mount the clamp garnish to the ceiling of the RV . Do not overtighten the
screws .
➤ Torque all screws equally . Do not overtighten .
I
For rubber roofs, use EPDM-compatible roof sealant .
4.4 Mounting the wall controls (RV mfg. models only)
4
Wall Control
Notch
➤ Locate the notch on the bottom edge of the controller and use a screwdriver in a twisting motion to remove
the back plate .
➤ Pull the RJ-11 controller cable (in the wall) through the square hole in the back plate (from the backside to the
front) and plug it into the front half of the controller .
➤ Hold the back plate to the desired wall location and secure it with two recommended #8 x 3/8" screws
through the two round holes in the back plate .
➤ Push the front half of the wall controller onto the back plate, being sure to align the connector plug with the
square hole, and snap both halves together .
5
Ceiling
Mounting
Flange
Roof
Clamp
Garnish
Cable
Back Plate
Fan Base
(Interior)
Back
Plate
(Model 4200 shown)
Fan
EN