Maintenance; Replacing The Fuse - Dometic Fan-Tastic Vent Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fan

6 MAINTENANCE

6.1 Replacing the fuse

13
Fuse
Fuse Cap
➤ Locate the black cap on the face of the screen
assembly . Twist the cap in a counter-clockwise
direction (from right to left) 1/4 to 1/2 turn, and
gently pull down on the cap . The cap should come
free with the fuse attached to the backside .
➤ Inspect the fuse to see if the wire inside the glass
is broken and replace if necessary . Be sure to use
only a 4 amp "slo-blo" fuse .
➤ Place one end of the new fuse into the backside of
the fuse-holder cap and gently push the other end
of the fuse all the way up inside the fuse holder .
➤ Screw the black fuse cap back into place by
turning in a clockwise direction (left to right) until
snug (1/4 to 1/2 turn), and release .
6.3 Fixing a stuck lid
DAMAGE HAZARD: If the EPDM rubber dome seal is damaged or torn, contact Dometic for a
replacement .
➤ Open the dome (lid) all the way .
➤ Place a liberal amount of denatured or rubbing alcohol on a clean rag and clean the underside of the lid and
the EPDM rubber seal .
➤ If available, apply a water-based (not petrolium-based) protectant to the inside of the dome where the dome
and seal meet . Allow the protectant to dry and buff the lid with a soft cloth to a high sheen .
➤ Use a clean rag, paper towel or foam trim brush to apply an even coating of 100% silicone to the entire top
surface of the EPDM rubber dome seal to prevent it from sticking to the lid .
I
Wipe excess fluid off hands and wash thoroughly with soap and water .
EN
6.2 Replacing batteries in the 7300/
7350 Remote Control
14
Finger
Tab
➤ To remove the battery compartment cover located
on the rear of the remote, pull back on the finger
tab and lift .
➤ Match the (+) and (–) markings on the batteries
to the (+) and (–) markings inside the battery
compartment .
➤ To close the battery compartment cover, place
the alignment tab located opposite the finger tab
into the square hole on the back of the remote .
Push the cover down until the finger tab clicks into
place .
Square Hole
Alignment
Tab
Battery
Compartment
14

Publicité

Chapitres

Table des Matières
loading

Table des Matières