Supplemental Directives; General Information; Intended Use - Dometic Fan-Tastic Vent Manuel D'installation Et D'utilisation

1.3 Supplemental directives


Read and follow all safety information and instructions to avoid possible injury or death .
Read and understand these instructions before installation or operation of this product .
Incorrect installation or operation of this product can lead to serious injury . The installation must comply
with all applicable local or national codes, including the latest edition of the following standards:
U.S.A.
• ANSI/NFPA70, National Electrical Code (NEC)
• ANSI/NFPA 1192, Recreational Vehicles Code

2 GENERAL INFORMATION

Recommended Hardware and Supplies
No . 8 Self-tapping flat-head screws (3/4" to 1" )
Gasket or Sealer
Recommended Tools and hardware
Putty Knife or Scraper
Cordless Drill with 1/8" Drill Bit
Straight Edge
Waterproof Sealant
16 #8 self-tapping flat-head screws
(3/4"–1")
Electrical/wiring information
• A minimum of 16-gauge stranded copper wire must be used .
• Insulated connectors must be used .
• Black wire = positive or fused; white wire = negative or ground .
• Fuse: 4 amp "slo-blo . "

3 INTENDED USE

The Fan-tastic Vent is intended for use with the recreational vehicle (hereinafter referred to as "RV") for which it
™
is supplied . The Fan-tastic Vent was designed to allow maximum airflow during the operation of vent fans while
providing additional protection from the elements .
The manufacturer accepts no liability for damage in the following cases:
• Faulty assembly or connection .
• Damage to the product resulting from mechanical influences and excess voltage .
• Alterations to the product without express permission from the manufacturer .
• Use for purposes other than those described in the operating manual .
3
Canada
• CSA C22 . 1 , Parts l & ll, Canadian Electrical Code
• CSA Z240 RV Series, Recreational Vehicles
Min . 16-gauge stranded copper wire
Insulated wire connectors
Standard #2 Phillips Screwdriver
Pencil or Pen
Measuring Tape
Utility Knife
2 #8 flat-head screws (3/8")
Fan
EN