Horizon Global 25004 Instructions D'installation page 6

7. Install hitch – Raise hitch into position. Fasten 8mm and 7/16 hardware to
brackets and then ½ hardware to tow hook (loosely tighten) see Figure 1. NOTE:
Tape washes to bracket for easier installation.
8. Tighten all 8mm fasteners with torque wrench to 20 Lb.-Ft. (27 N*M).
Tighten all 7/16-14 Gr5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M).
Tighten all 1/2-13 Gr5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M).
10. Reinstall the fascia, wiring harness, fasteners, wheel liners and taillights removed in Step 2-5.
©2022 Horizon Global™ Corp - Printed in Mexico
9. Trim fascia – Locate the center of fascia. Use a tape measure, marker, and
die grinder, to cut a 3"x1.50" notch in the bottom of fascia. See Figure 2. Note:
Be sure area is clear of all electrical wiring before trimming.
TRIM AREA
1.50"
Sheet 6 of 18 25004NP
CL
3"
Figure 2
1-24-22 Rev. A