Horizon Global 25004 Instructions D'installation page 4

1. Remove plastic trim piece – Use flathead screwdriver to remove (3) push
rivets from plastic trim piece located under fascia. Use phillips screwdriver to
loosen (1) christmas tree screw from plastic trim piece. Remove and return to
owner.
3. Remove hardware from fascia - a) Use flathead screwdriver to remove (2)
push rivets connecting fascia and impact bar.
©2022 Horizon Global™ Corp - Printed in Mexico
2. Remove taillights – Use phillips screwdriver to remove (2) screws from
driver side taillight. Use plastic trim tools to gently disconnect the taillight from
the vehicle and set aside. Repeat this process for passenger side.
3b) Use flathead screwdriver to remove (2) push rivets from bottom passenger
side of fascia. Repeat for driver side.
Sheet 4 of 18 25004NP 1-24-22 Rev. A