Publicité
STEP 4
Using the 5 mm Allen wrench
and a 3/8" wrench, remove
the ironing board and support
brackets from the slides
(See Figure D).
STEP 5
Reattach the ball-bearing slides
to the slide assembly (See
Figure E).
STEP 6
Close both slides and apply the
double-sided tape to the front
of the slide flanges.
Note: Cross braces MUST be
parallel and horizontal (See
Figure F).
INSTALLATION INSTRUCTIONS: 15L PIVOT OUT WASTE CONTAINER
FIG. D
FIG. E
FIG. F
3
Publicité
