Table des Matières
Publicité
Step 15
Fasten the BASE MOLDINGS (Y and Z) to the BOTTOM (G2).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten the END MOLDINGS (CC) to the BACKS (I and J). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: There are no pre-drilled holes in the END
å
MOLDINGS (CC). The SCREWS will tighten into the grooves.
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
Page 20
1S
I
402902
CC
J
G2
Y
CC
Z
www.sauder.com/services
Publicité
Table des Matières
