Power Fist Hydraulic Shop Press Mode D'emploi page 8

9081555
2. Position the lower crossbeam (#18) so the bolt holes align with the lower
bolt holes at the bottom of the left post. Insert a bolt (#11) through each
bolt hole from the inside. Do not secure yet.
3. Position one base (#14) over the protruding bolts. Secure each bolt with a
washer, lock washer and nut until hand-tight.
4. Secure a strut (#12) to each end of a base with an M10x30 bolt, M10
washer, M10 lock washer and M10 nut until hand-tight.
5. Secure the free end of each strut to the second set of bolt holes from the
bottom with an M10x30 bolt, M10 washer, M10 lock washer and M10 nut.
6. Tighten all nuts in steps 3 to 5 with a wrench.
7. Repeat steps 1 to 5 with the right post. Do not connect the rear support
strut to the right post. This will be done later.
8. Slide the upper crossbeam (#1) onto the posts and align the bolt holes.
Insert M16x40 bolts from the outside through all eight bolt holes. Secure
each bolt with an M16 washer, M16 lock washer and M16 nut.
9. Raise the shop press frame upright.
10. Thread the pressure gauge (#38) into the pressure gauge connection nut
at the top of the ram.
11. Thread the upper round nut (#37) onto the ram until it reaches the
top threads.
12. Slide the ram through the opening in the under plate until the upper round
nut is sitting on top of the plate. Position so the pressure gauge is facing
the front.
13. Thread the lower round nut (#39) onto the ram from beneath and tighten
to secure the ram to the under plate.
14. Center the ram assembly in relation to the frame. Tighten the nuts
securing the upper crossbeams to the posts with a wrench to hold the
ram in place during operation.
15. Push each bed frame pin (#9) through the matching set of holes on the
left and right side of the frame. The bed frame will rest on these, so
ensure they are level with each other. Secure the pins with the included
clips (#10).
16. Position the bed frame so the beams are outside of the leg assemblies.
Lower until the bed frame is resting on the pins.
www.princessauto.com / 1-800-665-8685
HYDRAULIC SHOP PRESS V1.0
Page 8