Assembling The Flange - Evenflo Feeding Mode D'emploi

Before First Use
Clean Your Pump Parts: To prevent warping, do not place anything on top of pump parts
during sanitizing, washing, or drying. Do not assemble pump until parts are cool and dry.
PARTS THAT MAY BE SANITIZED:
Bottle Valve Membrane Diaphragm
Flange Flange Sealing
Inserts Disc Cap Ring
PARTS THAT ARE HAND WASH ONLY:
Diaphragm Cap
DO NOT WASH:
Pump Unit AC Adapter
Tubing Adapter Tubing
Before Every Use
• Wash your hands with soap and water before handling your pump.
• Ensure parts are clean and dry. Refer to cleaning instructions on page 14.
• Use care when handling the valve/membrane assembly to avoid damage.
• Visually inspect the individual components for cracks, chips, tears, or deterioration. In
the event that damage to the device is observed, please discontinue use and purchase
replacement parts.
6
USA/Canada: 1-855-EFI-BABY (334-2229) • www.evenflofeeding.com
To Sanitize Parts on the Stove:
• Place disassembled pump parts in a pan of
boiling water for 5 minutes. Stir frequently.
• DO NOT allow parts to rest on bottom of pan
as they may melt or become damaged.
To Sanitize Parts in the Microwave:
• Use Evenflo Feeding Silicone Steam Sanitizing
Bag according to instructions
Bottle
IMPORTANT
DO NOT BOIL OR SANITIZE IN
MICROWAVE. Boiling or sanitizing in the
microwave will damage these parts and
the PUMP WILL NO LONGER WORK.
WARNING
NEVER immerse pump unit or AC
adapter in water or attempt to sanitize in
a microwave oven. Damage to parts and
oven may occur. Do not boil or wash tubing
or tubing adapter. Wipe the pump unit
with a clean, damp cloth as needed.
A
B
Note: If the membrane is not lying flat against the valve, the pump will lose suction and
will not work properly. Also, make sure the membrane is not torn, as this too will cause
decreased suction and the pump not to work properly.
C
B
D
F
E
C
F
G
USA/Canada: 1-855-EFI-BABY (334-2229) • www.evenflofeeding.com

Assembling the Flange

1
Attach the membrane A to the valve B.
Ensure membrane can move by gently lifting
the membrane away from the valve. The
membrane should return to lie flat against
the valve.
2
Push valve assembly B onto the bottom of
the flange C. Screw bottle D into
bottom of flange.
3
Install diaphragm E and firmly snap dia-
phragm cap F on to flange assembly C.
Note: Orient diaphragm cap as de-
sired before snapping into place.
4
Attach tubing G to diaphragm cap F.
Note: If you intend to pump from both
breasts at the same time, repeat steps
1 through 4 for the second flange.
7