Connecting A Gate Motor; User Manual; Using The Videophone; Videophone Settings - Extel COMPACT Guide D'installation Et D'utilisation

Important: The electric strike plate or lock that you install must be equipped with a mechanical memory and have
low power consumption, as for all EXTEL models. For wiring, refer to the label on the back of the camera.
Important:
• The maximum distance between the intercom panel and the electric strike plate or electric lock is 50 m maximum.
The wire size to be used is 0.75 mm².
• The use of a 12 V/1.1 A max. electric strike plate with WECA mechanical memory (Extel reference 109021 or 109031)
or WECA 5001/2 10 SER R1 (reference 150011) is recommended.
c. Connecting a gate motor (fig. 6)
Directly connect the gate motor wires to terminals 3 and 4 on the back of the camera. The camera provides a
'dry'-contact connection, without an electric current, to connect to the button for your automated gate.
Important:
• This function is only valid if the screen is on
• The maximum distance between the intercom panel and the gate motor drive is 50 m maximum. The wire size
to be used is 0.75 mm².
• The product has been tested and approved with Thomson "Sésame" or "Swip" gate motor drives which can be
found at maisonic.fr

6. USER MANUAL

a. Using the videophone
• Pressing the intercom panel button triggers an audible signal and the monitor turns on for
around 30 seconds. Once you have identified the visitor, press the
Note: Press the button once to initiate communication with the intercom panel.
• When your conversation is finished, wait for the end of the timer (about 2 min.) or press the
to turn off the monitor.
• To bring back the video feed:
To bring back the video feed for an extra 60 seconds, press the
• Control of an electric strike plate:
The strike plate or lock is opened when your press the
• Automatic opener control:
To control an automated gate, press the
NB: Note that gate opening functions are only valid if the screen is on.
b. Videophone settings
• Access the settings menu by pressing
• Ringtone selection.
• Doorbell volume setting.
• Contrast setting.
• Brightness setting.

7. TECHNICAL CHARACTERISTICS

a. Monitor
• Power supply: 17 V
• Consumption: 7.65 W (450 mA)
• Screen: 4" (10 cm)
• Resolution: 320 x 240
• Dimensions (mm): 140 x 120 x 17
b. Power supply
• Reference: 830216
• Adapter: 100-240 V∼, 50/60Hz; 17 V , 1.5A
button.
(fig.2)
+
Master Slave
EXTEL COMPACT - ADDCOMPACT
key to communicate with them.
button.
button.
or buttons
GB4